Cutting Tools
We design and manufacture cutting tools for ESCOMATIC machines such as the D6 and D2. Tools with tight tolerances are finished to within 1µm.
Products
Ground while watching the deviation at 500×
We grind each tool while checking its deviation from the target with a 500× camera. Tools with tight tolerances are finished to within 1µm.
Quality control
On request, we measure every single bite strictly and deliver high-quality tools.
Form tool samples Click a photo to enlarge
We make form tools with radii, angles and steps to match your drawing, and measure them before finishing.
Materials
We offer tools in many materials. Our most requested is 91.8 HRA ultra-fine-grain carbide; we can also make tools in cermet, other carbides or your preferred material.
| Hardness (HRA) | Transverse rupture strength (kgf/mm²) | Compressive strength (kgf/mm²) | Co content (%) | Grain size (µm) |
|---|
Coating comparison
We recommend coating when cutting steel, stainless or bearing steel (SUJ). Our standard recommendation is the hardest option, our main coating.
Damage-less laser marking
We mark clear, legible characters while keeping damage to the carbide tool to a minimum. Each marked serial number is linked to the tool's inspection data.
